This will take Kontakt's separate insert outputs and send them to FL's mixer tracks. Go ahead and click that, then Kontakt will disappear and FL greets you with wrapper settings.

At the top left you'll see FL Studio's options for the VST, along with a gear icon. Open the Kontakt window (click Kontakt 4 or 5 in the step sequencer). Now it's time to connect Kontakt to FL Studio after adding it as a channel. Now, add Kontakt 4 (or 5) as a channel in FL Studio. If you see three different Kontakt names in red, you done good. Never use this unless you're bored.) Now look at the list again. Click it and hit “Fast Scan” (Scan & Verify is just a dumb thing that separates instruments from effects, it takes a while and throws over 9000 error messages at you. If you don't see it, look for Refresh on the bottom right corner of the list. Check mark it and skip the rest of this section. If you see it (you shouldn't), then great. “Why isn't FL Studio displaying Kontakt in the channel list?” (if it is, skip this section.) The simple answer is that FL Studio needs to be told to rescan your VST folder in order for it to recognize your new VST's as channels to load. But the problem is that I would have liked to draw control envelopes similar to those used for volume automation or, alternatively, to use continuous control, but that does not seem to be possible.Īny help from you about the previous matter would be greatly appreciated.When you first install Kontakt on the path to sampled stardom you may realize that some things aren't going well. I could however confirm that the pitch is altered through this method, which is good news. I looked for information anywhere in the net I seem to have understood that I have to create a new lane (wheel type) in order to implement pitch bend control, but I find it truly hard to draw 'control evelopes' using the Draw Freehand tool. I now need to automatize a number of pitch bends and/or modulations to the track, but I have no clue about how to do it. This is the situation: I have a Shreddage 3 Stratus MIDI track (recorded using a MIDI keyboard that has no wheels for pitch and modulation). I am struggling to find instructions about how to implement pitch bend automation in Cakewalk, on a clip built with Shreddage 3 Stratus (Kontakt).īefore writing the present message, I looked for information about this problem, in the Shreddage 3 Stratus community it seems that the pitch automation issue is DAW-related, so here I am, being I a (non expert) Cakewalk user.

Shreddage 3 kontakt how to install